:: Powerplan ::

Introduction Product Information Technical Support & CAD Assistance Component Parts Starting Points Switchable Distribution Units Cables and Leads PIR Sensors ‘T’-Pieces Power Distribution Applications Circuit Distribution Boxes Lighting Control Modules Switch Modules & ‘T’ Pieces Power Distribution Technical Data

Introduction Product Information Busbar Layout Information Technical Information

Introduction 3 & 4 compartment floor boxes – push fit 2, 3 & 4 compartment floor boxes – screw fit Slab Boxes Accessory Plates

Introduction cable hives cable grommets clamping methods and capacity info

Introduction Under desk Conti Connect Modules Elite Power Modules Power Master eco₂ power^TM modules Through Desk Horizon Module Affinity Module Eclipse Module Shuttle Module On Desk Wedge Harmony Module Harmony Module Cables & Connectors

system components

starting points

unarmoured

armoured

master distribution box (MDB)

A pre-wired multi circuit distribution box. Allows up to 9 separate circuits to be taken directly to a strategic area from the distribution board. 6 pole output connectors allow for various lighting and power configurations.

starter lead

Starts a pluggable circuit from a free end to a female connector e.g. direct from the distribution board or from our busbar system pre-wired with the busbar tap off plug.

1-4 circuit starter box

Can pick up hard wiring on central trunking or our busbar system via the busbar tap off and enable up to 4 separate circuits to be fed from it.

circuit splitter modules

Enables a circuit to be split 3 ways.

See a PDF of this page