:: Powerplan ::

Introduction Product Information Technical Support & CAD Assistance Component Parts Starting Points Switchable Distribution Units Cables and Leads PIR Sensors ‘T’-Pieces Power Distribution Applications Circuit Distribution Boxes Lighting Control Modules Switch Modules & ‘T’ Pieces Power Distribution Technical Data

Introduction Product Information Busbar Layout Information Technical Information

Introduction 3 & 4 compartment floor boxes – push fit 2, 3 & 4 compartment floor boxes – screw fit Slab Boxes Accessory Plates

Introduction cable hives cable grommets clamping methods and capacity info

Introduction Under desk Conti Connect Modules Elite Power Modules Power Master eco₂ power^TM modules Through Desk Horizon Module Affinity Module Eclipse Module Shuttle Module On Desk Wedge Harmony Module Harmony Module Cables & Connectors

system components

power distribution

unarmoured

armoured

starter lead

Starts a pluggable circuit from a free end to a female connector e.g. direct from the distribution board or from our busbar system pre-wired with the busbar tap off plug.

extender lead

Allows circuits to be extended via a male and female connector.

power drop lead

Allows for connection via a male connector whilst being hardwired at the fitting e.g. from an MDB to hand driers.

‘t’ piece

Allows power to be fed to a local device without ending the circuit.

switched fused spur ‘t’ piece

Provides a through connection point for fan coils requiring fused protection and isolation. Pin configuration is dedicated to power circuits.

See a PDF of this page