accessory plates
3 compartment version for 20, 20A & 99
100mm wide(Finish-Lt. Grey Paint RAL7035)
plate ref
CP 301
CP 302
CP 3003
V 304

V 305

B 306
M 307
V 311

V 342

DV 397

D 3107

D 331
description
1 twin 13A switched socket
1 twin 13A unswitched socket
3 single 13A unswitched sockets
Plate pierced to accept 4 x LJ6C/RJ45 (Piercings 37.0 x 22.3)
Plate to accept 2 x LJ2 telephone outlets (Units 68mm Square)
Blank plate
Standard BS 1363 2 gang piercing
Plate to accept 2 x standard 1 gang fittings (Units 86mm Square)
Plate pierced to accept 6 x LJ6C/RJ45 (Piercings 37.0 x 22.3)
Angled plate pierced to accept 4 x LJ6C/RJ45 (Piercing 37.0 x 22.3)
Plate pierced to accept 4 x RW Data/Alphasnap Units (Piercings 48.0 x 23.5)
Plate pierced to accept 2 x Euro (50mm x 50mm) Adapter Collars
4 compartment version for 20, 20A 93 & 99
75mm wide(Finish–Lt. Grey Paint RAL7035)
plate ref
CP 401
CP 402
CP 403
V 404

V 405

B 406
V 442

DV 497

D 4107

D 431
description
1 twin 13A switched socket
1 twin 13A unswitched socket
3 single 13A unswitched sockets
Plate pierced to accept 4 x LJ6C/RJ45 (Piercings 37.0 x 22.3)
Plate to accept 2 x LJ2 telephone outlets (Units 68mm Square)
Blank plate
Plate pierced to accept 6 x LJ6C/RJ45 (Piercings 37.0 x 22.3)
Angled plate pierced to accept 4 x LJ6C/RJ45 (Piercing 37.0 x 22.3)
Plate pierced to accept 4 x RW Data/Alphasnap Units (Piercings 48.0 x 23.5)
Plate pierced to accept 2 x Euro (50mm x 50mm) Adapter Collars
Sockets are available in clean earth versions. All twin sockets have a dual earth facility to enable compliance to BS 7671:2001 Regulation 607-02-05 (Section 607).
If the accessory plate you require is not included in the most widely used selection shown above, please ring technical sales for further information.
See a PDF of this page